Fisher & Paykel DD24 Series User Manual page 29

User _aintenanc@
CJeaning the spray arm and fiJter p_ate
Ensure the DishDraweP is cool before you start cleaning and follow the instructions for
removing the drain filter and spray arm.
I{_ Unclip the glass supports from the rack wires and
fold all the adjustable racks away, so that they are
upright and dose to the top,
2 Remove the base rack carefully. Lift from the
back end first to prevent knocking the
detergent and rinse agent dispenser,
s Lift the spray arm and shake any foreign material
out
Rinse the spray arm clean under running water
and wipe the with a damp cloth,
4 In the center of the filter plate there are two rings.
Hold the center ring still and turn the outer ring
counter-clockwise, about a 1/8 turn, This will
release the filter phte,
5 Lift thefilter plate out
When cleaning the underside of the filter [:)late,
take care handling the sharp outer edge to avoid
the risk of cuts,
Remove any foreign material, wash in hot soapy
water and rinse thoroughly in dean water. The
heater plate can be wiped with a damp clotL
6 Replace the filter plate so it lies flat in the base of
the drawer ensuring the filter plate is fully locked
into position with the center ring.
7
8
_9 tock the fi#er ptate ff}to _ition, ensure the lines atign
with each other (c) and a_lthree pin pairs fiffnty ff_teflock (e)o
Referto the diagram forthe correct posLffono
The tiger pJate must not be able to move about ffedyo
Replace the spray arm back onto the impeller,
Replace the base rack, lowering its front edge into
position first.
Note: Where there is broken crockery or glass in the
drawer, it must be carefully removed to prevent
damage to the DishDrawer%
Correct locking position of filter
plate with motor assembly
(under spray arm)
a Outer ring
b Impeller
c Correct alignment marks
d Center ring
e Interlocking pins