Table Of Loose Parts - Craftsman 113.232240 Owner's Manual

Unpacking
WARNING: To avoid injury from unexpected starl-
ing or electrical shock, do not plug the power cord
into a power source outlet during Unpacking, until
all assembly steps are complete, and you have
read and understand the safety and operating
instructions.
WARNING: Although compact, this tool is heavy.
To avoid back injury, get help whenever you have
to lift the tool.
Your jointer/planer is shipped complete in one carton and
includes steel legs,
1. Clear yourself a large work area. Remove the jointed
planer and parts from the carton. Lift-the tool at the
bottom of the base.
2. Place the tool on a secure, stationary work surface and
look it over carefully.
3. Separate all parts from packing materiels and check
each one with the "Table of Loose Parts" and the "List
of Loose Parts" to make certain all items are
accounted for before discarding any packing material.
If you are missing any parts, chect_ packing material for
those items.
WARNING: if any parts are missing, do not attempt
to assemble the jointerlplaner. Do not plug in the
power cord or turn the switch on until the missing
parts are obtained and are installed correctly.
4. Contact your Sears Service Center to get the missing
parts. Use the "Repair Parts" pages at the end of this
manual to identify the part number of the missing parts
after completing the "Unpacking and Checking Con-
tents section.
5. Remove the protective oil that is applied to all
unpainted sudaces. Use any ordinary household type
grease and spot remover,
I WARNING: To avoid fire or health hazard, never use t
. gasoline, naptha, or similar highly volatile solvents.
6_ Apply coat of paste wax to the tables and fence.
7. Wipe al! parts thoroughly with a clean, dry cloth.
Table of Loose Parts
NOTE: Before beginning assembly, check that all parts F
are included. If you are missing any part, do not assem- G
ble the tool, Contact your Sears Service Center to get the H
missing part. Sometimes small parts can get lost in pack- J
aging material. Do not throw away any packaging until K
jointer/planer is put together. Check packaging for miss- L
ing parts before contacting Sears. A complete parts list M
(Repair Pads) is at the end of the manual: Use the list to N
identify the number of the missing part, P
Q
The following parts are included: R
S
T
U
V
item Part Name Qty.
A Jointer Bed Assembly ...................................... 1
B Fence ............................................................... 1
C Motor ................................................................ 1
D Motor Pulley w/Set Screws .............................. 1
E V-Belt ............................................................... 1
Push Blocks ...................................................... 2
Top Panel ......................................................... 1
Stand Front Panel ............................................. 1
Stand Rear Panel ............................................. 1
Stiffeners ........................................................... 2
Lower Motor Bracket ......................................... 1
Top Stiffener ..................................................... 1
Vertical Motor Bracket ...................................... 1
Cutter Guard ..................................................... 1
Pulley Guard ..................................................... 1
Handwheet ........................................................ 2
Cover ................................................................ 2
Rear Guard ........................................................ 1
Owner's Manual ................................................ 1
Bag Loose Parts ............................................... *
Quantity of bag may vary, bags may contain
smaller bags