Storage Drawer; Troubleshooting - Estate TGS325MT5 Use & Care Manual

4.
Lift the oven door while holding both sides.
Continue to push the oven door closed and pull it away from
the oven door frame.
The storage drawer can be removed. Before removing, make sure
drawer is cool and empty.
To Remove:
1. Pull the storage drawer straight back past the drawer stop
notch and the end of the side rails.
To Replace:
1. Insert both hanger arms into the door.
2.
3.
Open the oven door.
You should hear a "click" as the door is set into place.
Move the hinge levers back to the locked position. Check
that the door is free to open and close. If it is not, repeat the
removal and installation procedures.
\
A. Drawer stop notch
B. End of side raft
2. Lift up the back of the drawer and pull the drawer out.
To Replace:
1. Lift up the back of the drawer and place it inside the range in
its fully forward position.
2. Lift up the front of the drawer to a level position.
3. Slowly push the drawer into the range until the drawer side
rails engage with the gap in the drawer glides.
A. Engage drawer glide.
4.
Once the drawer is fully engaged on both sides, slide the
drawer back into the closed position.
NOTE: When you are removing and replacing the storage
drawer, a slight push may be needed to move the drawer
stop notch past the drawer glides.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate Surface burners will not operate
• Is the power supply cord unplugged?
Plug into a grounded 3 prong outlet.
• Is the "Cooktop Lockout" set?
See "Cooktop Lockout" section.
Household fuse blown or circuit breaker tripped? •
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
Is the main or regulator gas shutoff valve in the off
position?
See Installation Instructions.
Is the range properly connected to the gas supply?
Contact a trained repair specialist or see Installation
Instructions.
Is the oven in self-clean?
Surface burners will not operate during self-clean cycle.
Is a delayed self-clean set?
Surface burners will not operate until the self-clean cycle is
complete.
Is the control knob set correctly?
Push in knob before turning to a setting.
16