Solutionsto Common Problems; Ovencontrolsbeepsand Displays"F"Code; Installation; Entireovendoesnotoperate - Electrolux E30EW8CESS1 Use & Care Manual

Solutions to Common Problems
OVENCONTROL BEEPSAND DISPLAYS "F" CODE
mmmmmmmmmmmmmmmmmmmmmm
• Electronic control has detected a fault condition. Push CANCEL pad to clear the
display and stop the display from beeping. Try to set a cooking function. If a fault
reoccurs, record the fault number, push the CANCEL pad and contact an authorized
servicer.
(NSTALLATION
• Place oven rack in center of oven. Place a level on the oven rack. Contact installing
agent if rack and cabinet cutout flooring are not level.
• Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets
are square and level. Contact cabinet maker to correct problem.
ENTIRE OVEN DOES NOT OPERATE
mmmmmmmmmmmmmmmmmmmmmm
• When the oven is first plugged in, or when the power supply to the oven has been
interrupted, the display will flash. The oven cannot be programmed until the clock is
set.
• Be sure electrical cord is securely connected into the electrical junction box.
• Cord/plug is not installed and/or connected. Cord is not supplied with oven. Contact
your dealer, installing agent or authorized servicer.
• Service wiring not complete. Contact your dealer, installing agent or authorized
servicer.
• Power outage. Check house lights to be sure. Call your local electric company.
• Short in cord/plug. Replace cord/plug.