Toremovethe "Hiddenbake Element" Cover; Ovenlight - Electrolux E30EW8CESS1 Use & Care Manual

Care & Cleaninq
TO REMOVETHE "HIDDENBAKE ELEMENT"COVER
1. In order to remove the "hidden bake" cover, pull the back edge with
one hand about 1/2" inch and lift up the "hidden bake" cover with
both hands. (See picture)
2. When reinstalling the "hidden bake" cover, be sure to put it all the
way to the back of the oven and lay it down on the 2 shoulder
screws. Then push the front edge of the cover in its place below the
front bracket.
To have easier access to the "hidden bake" cover, first remove the oven
door by following the instructions above.
IMPORTANT: Always replace the "hidden bake" cover before the next
use.
OVENLIGHT
An interior oven light will turn on automatically when the oven door is opened. The oven
light may be turned on when the door is cJoeed by using the oven Jight switch Jocated on
the control panel.
The lamp is covered with a glass shield. The glass shield can be remove to be cleaned
manually or to change oven light.
THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
CAUTION: BE SURE THE OVEN IS COOL.
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken
glass.
3. To remove the glass shield, pull the back side of the shield toward
the inside of the oven in a manner to lift it up from the oven side.
4. The glass shield should come out easily by pushing a little toward
front of the wall oven.
5. Replace halogen light appliance bulb taking care to not touch the
bulb. If you touch the halogen bulb with finger that can damage it
and also burn it.
6. To replace glass shield, proceed in reverse.
Lift backside
of glass shield
and remove it.
Halogen
Light Bulb