Craftsman 358.341180 Operator's Manual page 15

TO REPLACE CHAIN:
1. Disconnect unit from power source.
2. Loosen and remove bar knob com-
pletely by lifting lever and turning
counterclockwise.
3. Loosen chain tension by turning
adjusting wheel (upward direction).
Remove bar clamp.
,_;'__ Knob
4. Slide guide bar on bar bolts toward
the drive sprocket until guide bar
stops against the sprocket.
5. Remove the old chain.
6. Carefully remove the new chain
from the package. Hold chain with
the drive links as shown.
Tip of
Bar
DIRECTION OF ROTATION
Cutters Depth Gauge
Drive Links
7. Place the chain around the sprock-
et and fit the drive links into the
guide bar groove and then into the
teeth of the sprocket in the tip of
the guide bar.
J
8. Pull guide bar forward until the
chain is snug in the guide bar
groove. Ensure all drive links are in
the bar groove.
9. Install bar clamp. Be sure adjusting
pin is in the adjusting pin hole in
the guide bar.
CAUTION: It is very important when
installing the bar clamp that the adjusting
pin aligns into the adjusting pin hole in
the bar. Failure to install the bar clamp
correctly may result in permanent dam-
age to your chain saw.
_m Back
view of
bar
P
Adjusting pin
10. Install bar knob; finger tighten only.
Do not tighten any further at this
point. Proceed to CHAIN ADJUST-
MENT,
CHAIN ADJUSTMENT
See CHECK CHAIN TENSION in the
MAINTENANCE section.
PARTS AVAILABLE
_ll WARNING: Use of any other ac-
cessory or attachment will present a
risk of injury to the operator.
REPLACEMENT PART
Oil Cap
Chain Catcher
Screw
File (5/32" dia,) Twin Pak
File Guide (File Holder)
Depth Gauge Tool
Chain -18"
Guide Bar - 18"
Bar & Chain Lubricant -1 qt.
Bar & Chain Lubricant -1 gal.
PART NO.
530053072
530029850
530016269
71-36524
71-36565
71-36557
71-3619
71-36638
71-36556
71-36554
15