Advertisement
Available languages
Available languages
Contents
of Carton
1 - Air Compressor
2-
Wheels
2 - Shoulder Bolts, 3/8-16
2 - Nex Nuts, 3/8-16
1-
Handle
1 - Handle Grip
2 - Cap Screws
2 - 1/4-20 Nex Nuts
2 - Retainer Clips
2 - Flat Washers
2 - Rubber Bumpers
2 - Screws, 1/4-20
x 3/4
Tools
Required
for Assembly
1 - 9/16" socket or open end wrench
1 - 1/2" socket or open end wrench
3.
Open End
Of Handle
Slowly push the open ends of
the handle onto both tabs at the
same time. Continue pushing the
handle into the saddle until the
holes on the side of the saddle
and handte are in line.
Remove unit from carton and discard
all packaging.
NOTE: Save all parts
bags.
To Install
Handle
The wheels and
handme do not
provide
adequate
clearance,
stability,
or support
for pulling the
unit up and down stairs or steps,
The unit must be mifted or pushed
up a ramp, Do not miftthe unit by
the manifomd assembly;
the unit
coumd be damaged,
1.
To make installation easier,
submerge handle grip into warm
soapy water. Remove handle
grip from soapy water and slide
onto handle.
A09713
Insert the open ends of the
handle under the saddle. Before
attaching handIe, you may have
to pul! the open ends of the
handle apart so they fit tightly
against the side of the saddle.
Looking in from the open end of
the saddle, position the handle
toward the two bent tabs, on the
inside walls of the saddle.
10- ENG
4.
Guide the straight end of each
retaining clip through the saddIe
hole and both handle holes.
Advertisement
