Table of Contents
Advertisement
Configuring RTSP Load Balancing
Before configuring your Web switch for RTSP load balancing, do the following:
n
Enable Virtual Matrix Architecture (VMA)
n
Enable Direct Access Mode (DAM)
n
Disable port-based Bandwidth Management
n
Disable proxy IP addressing
1.
To configure a virtual server for Layer 4 load balancing of RTSP, select rtsp or port
554 as a service for the virtual server.
>> # /cfg/slb/virt <virtual server number>/service rtsp
2.
To configure a virtual server for Layer 7 URL hashing of RTSP, select rtsp as a virtual
service and enable rtspslb.
This command enables URL hashing using the entire URL; however, any extension of the type
(.xxx) occurring at the end of the URL is omitted from hash computation.
>> # /cfg/slb/virt 1/service rtsp/rtspslb hash|pattern|dis
3.
Apply and save your configuration.
>> Virtual Server 2 rtsp Service# apply
>> Virtual Server 2 rtsp Service# save
212777-A, February 2002
Web OS 10.0 Application Guide
Chapter 6: Server Load Balancing
n
157
Advertisement
Table of Contents
