Table of Contents
Advertisement
6.
Set the bandwidth policy for the contract.
Each BWM contract must be assigned a bandwidth policy.
>> BWM Contract 1# pol 1
7.
Enable the BWM contract.
>> BWM Contract 1# ena
8.
Create a filter that will be used to classify the frames for this contract and assign the
BWM contract to the filter.
The classification policy for this BWM contract is based on a filter configured to match ICMP
traffic. The contract will be applied to any frames that match this filter
>> BW Contract 1# /cfg/slb/filt 1/proto icmp
>> Filter 1# adv/icmp any
>> Filter 1 Advanced# cont 1
>> Filter 1 Advanced# /cfg/slb/filt 1/ena (Enable this filter)
>> Filter 1# apply
9.
On the switch, apply and verify the configuration.
>> Filter 1 Advanced# apply
>> Filter 1 Advanced# /cfg/bwm/cur
Examine the resulting information. If any settings are incorrect, make the appropriate changes.
10.
On the switch, save your new configuration changes.
>> Bandwidth Management# save
11.
On the switch, check the BWM information.
>> Bandwidth Management# /info/bwm <contract number> (View BWM information)
Check that all BWM contract parameters are set correctly. If necessary, make any appropriate
configuration changes and then check the information again.
212777-A, February 2002
Web OS 10.0 Application Guide
(Assign policy 1 to BWM contract 1)
(Enables this BWM contract)
(Define protocol affected by filter)
(Set the ICMP message type)
(Assign BWM contract 1 to this filter)
(Port and enable filtering)
(Make your changes active)
(View current BWM settings)
(Save for restore after reboot)
Chapter 17: Bandwidth Management
n
469
Advertisement
Table of Contents
