Attaching Sears Router Model No. 27504; Attaching Sears Router Model No. 27505 And 27506; Attaching Other Brands Of Routers - Craftsman 171.25490 Owner's Manual

3.Rotate therouteruntilthethreemounting I'_oles inthe
router base lineup with three af4he holes in the throat
plate. (It will be helpful il you orient the router such
Ihat you can easily reach the ONIOFF switch from the
front of the table. Sears Craftsman 925090 Router
Table Switch Package provides easy access to ON/
OFF button).
4, Insert three #10-32 x =t6"long flat head machine
screws (provided) through holes in the throat plate
and tighten securely, into the router base. See
Figure 7,
Table Top
#10-32 x 3/€
Flat Head Screws
\
Router
FIGURE 7.
Tab!e Front
In st_p 4, use the three _/'_s-18x !" long flathead screws
provided. These screws are black in color.
ATTACHING OTHER BRANDS OF REUTERS
NOTE: Reuters having a total overall height of 13 .
inches or less and a base diameter of 7 inches
or less can be accommodated.
1.11 the throal plate I_as already been assembled to the
table, remove it, IF NOT, proceed wilh step 2.
2. Place the throe1 plate on a flat surface so that the
locations of the holes are shown as in Figure 3.
3. Place the router upside down next to the throat plate
so that the handles are aligned as shown in Figure 8.
4. Remove the base from the rouler, set aside the
screws, and place the base plate on the lhroat plate.
NOTE: DO NOT FLIP OR ROTATE THE BASE PLATE
WHEN DOING THIS.
5. Posilion the base plate so the hole in the base plata is
centere_ with the hole in the throat plate. It may be
necessary to relate the base plate slightly so Ihal no
hole in the plate line-ups with a hole in 1he throat
plate•
ATTACHING SEARS ROUTER MODEL NO. 27504
Proceed as with three hole base elate reuters exceot; as
in =.tap _, line uptrie lout:large threacted holes in the
router base with the four la.ri3e counler_unk hi31_s in lh_
ith£oat.platel
NOTE: Router will l in_.e up in one position on.ly.
In step 4, use the four large 1" long (MS x 25 Metric)
flathead screws provided. These screws are silvery in
color.
ATTACHING SEARS ROUTER MODEL NOS, 27505
AND 27506
Proceed_as with three hole base plate touters exoeptas
_follows:
!n step & !!ne-up me three t arge;threa_ec! holes in the
r.o_ter haae.wi.tl3 the,three,correspond ng lare counter-
sunk holes in the throat plate lhat rnalch.
NOTE: Router will lineup in one position only.
i
i';. " :FIGURE 8.
6, Mark the-positionOf tile. mounting holes On the base
plate with a pencil or felt tip marker. That is, the base
plate is being used as a temp!ate to locale the holes
on the lhroal plate.
7. Select a drill bll with a diameter that is the same as or
slightly Digger than the head of the screw which.held
the base plate on the router. (Reler to Step 4 above.)"
_S