Assembly Of Unitized Fence; Assembly Of Jointing Fence To Unitized Fence; Attachment Of Unitized Fence Assembly To Table - Craftsman 171.25490 Owner's Manual

ASSEMBLY OF UNITIZED FENCE
WARNING: BEFORE ASSEMBLING AND AT'rACI_.
ING UNITIZED FENCE TO TABLEs MAKE SURE THAT
ROUTER IS UNPLUGGED AND THE BIT IS BELOW
THE TOP SURFACE OF THE TABLE.
ASSEMBLY OF JOINTING FENCE TO UNITIZED
FENCE
1. Slide joinling fence through rectangular opening in the
cavity, provided on the unitized fence (V-guide on the
unit_.ed fence will slide in the V-guide on the under
side of jointing fence). See Figure 10.
2. Insert 1/,-20 x 1" long hex head bott through Ihe
hole in the unilized fence (from the underside) and the
slot in the jointing fence.
3. While holding the head of the boil in the hex recess
on the underside of unitized fence, place a flat washer
over the bolt and screw small %-20 knob on bolt.
When knob is loosened, the jointlng fence can slide back
and forth in the cavity for proper jointing adjustment.
You will observe as you face the front of the lab_e, that
on the right side of the table top there are two round
holes approximately =/=" in diameter, and on the left
side, tha_a is a 4" long slol. These are used to attach the
fence to the table,
For all edge cutting and end cutting operations, attach
fence using the front hole and the slot. See Figures 11
and 12 for available fence adjustment on either side of
the muter bit center.
FIGURE 11.
FIGURE 10.
ATTACHMENT OF UNITIZED FENCE ASSEMBLY TO
TABLE
ALWAYS UNPLUG ROUTER BEFORE ATTACHING
FENCE TO OR REMOVING tT FROM TABLE,