NOTE: OPERATING ROUTER TABLE WITHOUT USE
OF WETJDRY VAC MAY RtS_SULT IN EXCESSIVE
OF SAWDUST AND CHIPS UNDER THE
FENCE AND THE GUARD.
REMOVE DUST AND CHIPS FROM UNDER Title
GUARD AND THE FENCE AS NEEDED TO MAINTAIN
GUARD AND FENCE FUNCTION.
MAKE SURE THE
ROUTER IS TURNED OFF AND THE BIT IS NOT
ROTATING WHEN DOING THIS. KEEP WORK AREA
MOUNTING THE ROUTER TABLE
THE ROUTER TABLE MUST ALWAYS BE FIRMLY
AND SECURELY MOUNTED TO A WORK SURFACE
BEFORE USE. FAILURE TO DO SO COULD CAUSE
TABLE TO TIP OVER OR SLIDE RESULTING IN
PROPERTY DAMAGE ANDIOR SERIOUS PERSONAL
A. TO A WORK SURFACE
Each leg has three slotted holes at the bottom for
mounting. Firmly secure router table to work surface,
using appropriate lasleners (not provided) as shown
in Figure 21. The stots are V4" wide x %" long and
screw sizes up to #'12.
B. TO SEARS LEG SET #22235
Assemble lag set as directed by the inslructions
included with the leg set.
1. Place the router lable on the assembled leg set wilh
the muter table base flush with the front of the leg set,
The holes in the base of the muter table should align
with holes in the leg set as shown in figure 22.
2. Secure the router table with hardware provided in
the leg set.
For added versatility, secure tho tabl_ -to a piece of V=';or
thicker plywood which can- be "C" clamped to your work