Carton Contents; Unpacking - Craftsman 137.212140 Operator's Manual

UNPACKING YOUR MITER SAW
'To avoid injury from unexpected sta_ing or electrical shock,
do not plug the power cord into a source of power dur}ng
unpacking and assembly, This cord must remain
unplugged whenever you are adjusting!assembling the
saw,
1. Remove the miter saw from the Carton. IMPORTANT:
Do not lilt the miter saw by the switch handle or miter
table handle.. It may cause misatignmenL Lift only by
the buill-In carry handle located at the topof the
machine.
2., Place the saw on a secure siafionary work surface.
3. Separate all parts from the packing material. Check
. each one with the illustration below lo make certain aJl
items are accounted for, before discarding any packing
material,
If any parl is missing or damaged, do not atlempt to
assemble the miler saw, or plug in the power cord until the
missing or damaged par_ is correctly replaced, To avoid
electric shock, use only identical replacement pads when
servicing double insulated lools.
Hold-down Cla_
Miler Table
Handle
Extension Wings &
Stop Block
/
/
/
]
Dust Bag
Blade Wrench
Exlension Wing
Locking Screws