Workpiece Support; Auxiliary Wood Fence - Craftsman 137.212140 Operator's Manual

WORKP|ECE SUPPORT (FIG. V) AUXILARY WOOD FENCE (FIG, W}
Long pieces need extra support° The support should When making multiple or repetitive cuts thai result in
be placed under the workpiece. Keep your hands out cut-off pieces of one inch or less, it is possible ior the
of the "no,-hands" zone, positioned 7.o1/4" or more saw blade to catch the cut-otl piece and throw it out o!
a.wayli'0rn t_'6l_de, The Suppod must:iet the -._-__ the saw or into the blade guard and,hous{ng, p_ssib!y,.
Workp_ece lay flat on the worktabte during the cutting causing damage or injury. To minimize thls an auxilia_
operation.
NOTE: When mounted on a fiat surface, the miter saw
table is 3-1/8 inches high
Fig, V
wood fence can be mounted to your saw
Holes are provided in the saw fence to attach an
auxiliary wood _ence. This fence is constructed of
straight auxiliary wood approximately 3/4 inch thick by
2-1/2 inches high by 18 inches long.
Attach the wood tence securely and make a full depth
cut to make a blade slot.
Check for intederence between the wood fence and
the lower blade guard. Adjust if necessary.
NOTE: This auxiliary fence }s used only w_th the saw
blade in the 0" bevel position (90" to the table)., The
auxiliary wood fence must be removed when bevel
cutting
Fig. W
\
3,1/8"
Cu_ting capacity with auxY[ia_ _ence
Crosscut _t2"
Miter 45'R. & L !3q12" x 2"
Bevel 45L. _1/2"
Compound 45'L.,45R & L, _2" x 2"