How To Install The Seat - Craftsman 502.270210 Owner's Manual

.............. . ................ ASSEMBLY
HOW TO INSTALL THE SEAT
Use the fasteners shown belowto instal!the seal The fastenersare
shown at full size.,
2,,
iiiiii!ltti
'"(Ai ..... (S)
lx45 18x16
(D)
2x53 15x88
Set the seat bracket on the seat support (Figure 5). Pull the
wire harness between the seat hinge and the seat brackeL
Fasten the seat bracket to the seat support with the fasten-
ers_ Do not tighten the fasteners.
Seat Hinge
Seat Bracket
C
Figure 5
3. Carefully remove the protectivesleeve and the plastic bag from
the seat, Do not damage the wire attached to the bottom of the
seat,.
4_ Align the holes in the seat hinge to the holes in the seat
(Figure 6)., Fasten the seat to the seat hinge with the fasteners
as shown. Tighten the fasteners
5_
Check the operating position of the seat. if the seat needs to
be adjusted, slide the seat bracket forward or backward along
the seat adjusting holes as shown.To keep the seat straight,
tighten the rear nut and then tightenthe two front nuts.
6,, Fasten the connector to the wire harness. Make sure the tab
on the connector locksinto the wire harness.
WARNING: For correct and safe operation of the unit,
fasten the connector to the wire harness, if the
connector is not attached, the engine will stop when
the attachment clutch is engaged.
CHECK THE LEVEL OF THE MOWER HOUSING
NOTE: After the unit is fully assembled, read the Operation
section,
The level of cut was set at the factory,.Tocheckthe level ofcut, mow
a short distance and look at the area that was cut. If the mower
housing does not cut level, see the instructions on "How To Level
The Mower Housing" in the Service And Adjustment section of this
instructionbook.
F-98668 10