Install Seat - Craftsman 917.28910 Operator's Manual

INSTALL SEAT
1, Remove bolt and fiat washer securing
seat to cardboard packing and set aside
for assembly of seat to tractor, Remove
the cardboard packing and discard,
2. Connect switch to seat_
3, Place seat on seat pan so all three (3)
bottom pads are positioned over large
slotted hoses in pan,
Slot
pan l / -J
I
Tape
Wiring harness
4,, Push down on seat to engage pads in
slots and pull seat towards rear of tractor,
5_ Raise seat and tighten bolt securely,
6., Remove tape and discard,,
7., Lower seat into operating position and
sit on seat, Press clutch/brake pedal all
the way down, If operating position is not
comfortable, adjust seat,,
Slot
NOTE: You may now roll your tractor off
the skid,, Follow the appropriate instruction
below to remove the tractor from the skid,
_WARNING: Before starting, read,
understand and follow all instructions in the
Operation section of this manual., Be sure
tractor is in a well-ventilated area. Be sure
the area in front of tractor is clear of other
people and objects,
TO ROLL TRACTOR OFF SKID (See
Operation section for location and
function of controls)
1., Raise attachment Iift lever to its highest
position,,
2,, Release parking brake by depressing
clutch/brake pedal,.
3. Place freewheel control in "transmis-
sion disengaged position" (See "TO
TRANSPORT" in Operation section of
this manual),
4. Roll tractor forward off skid,
5., Remove banding holding the deflector
shield up against tractor
Continue with the instructions that follow,
Flat
washer
\
pan
Adjustment
Bolt Tab
handle
TO ADJUST SEAT
Grasp adjustment handle and pull up, slide
seat to desired position and release adjust-
ment handle.