Instruction Manual LAWN EDGER ATTACHMENT Model No, C944.511570 • Safety • Assembly • Operation • Maintenance • Parts List • Franqais WARNING: Read and follow all Safety Rules and Operating Instructions before first use of this product. For answers to your questions about this product: Call 7 am-7 pm, Mon.-Sat., or 10 am-7 pm, Sun.
Maintenance Parts and Ordering Back Cover LIMITED TWO (2) YEAR WARRANTY ON CRAFTSMAN ® LAWN EDGER ATTACHMENT For two (2) years from the date of purchase, Sears Canada, Inc., will repair or replace free of charge, at Sears option, parts which are defective as a result of material or workmanship.
ence ofalcohol, drugs, ormedication. with the suffix W. Make sure your ex- Watch w hat youaredoing; usecorn- tension cord is in good condition. In- mOB s ense. spect extension cord before use and • Wear h earing protection. replace if damaged. An undersized •...
The lawn should always be carefully • Use only recommended Craftsman examined and cleared of all objects parts and accessories. Never use prior to edging.
Blades can throw objects violently • You can be blinded or injured. Safety Boots • Wear safety glasses and boots. Glasses Hazard zone for thrown objects • Blades can throw objects violently. • Others can be blinded or injured. WARNING: •...
CARTON CONTENTS Spacer Tabs Check carton contents against the fol* positioned for use--_ lowing list. on 1" diameter _._,,,_ Model C944.511570 Edger Attachment upper tube Handlebar (with clamp and knob) Clamp Base (with spacer tabs) 1. Place the tube clamp over the up- Clamp screws (4) per tube above the arrow on the Attachment hanger...
KNOW YOUR EDGER ATTACHMENT READ THIS INSTRUCTIONMANUALAND SAFETY RULES BEFOREOPERATINGYOUR EDGER ATTACHMENT. Compare the illustrations with your attachment to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference. Hanger Depth Adjustment Knob Tube Blade Shield Gearbox...
INSTALLING ATTACHMENT WARNING: Never attempt to 1. Remove the tube cap from the at- adjust the edger wheel when the unit tachment (if present) and discard. is in operation. Always stop the pow- 2. Position locking/release button of erhead, wait until the blade stops turn- attachment into guide recess of up- ing, and disconnect the spark plug (or...
1. Loosen the depth adjustment knob. 2. Slide the wheel to the desired posi- tion. • Raising the wheel will increase the cutting depth. • Lowering the wheel will decrease the cutting depth. 3. Tighten the depth adjustment knob securely. MAINTENANCE SCHEDULE WARNING:...
BLADE REPLACEMENT 3. While holding the screwdriver in position, remove blade nut by turn- _WARNING: The blade will con- ing clockwise. tinue to spin after the engine stops or 4. Remove both washers, and the blade from the blade shaft. after the throttle trigger has been re- leased.