Product Description; Removing The Blade; Electrical Connection; Trigger Switch - Craftsman 320.10860-01 Owner's Manual

MOUNTING THE BLADE TO SAW cont.
Bushing
indle
Outer "D" Washer
,L_ _;_ Blade
Screw
10. Replace the "D" washer (See Fig. 1).
11. Firmly hold down spindle lock button as you replace blade screw and hand tighten it in a
clockwise direction (See Fig, 1). Then use blade wrench to tighten blade screw thoroughly°
12. Place blade wrench back in shoe°
NOTE: Always place angled portion of blade wrench upwards.
IMPORTANT: NEVER use a blade that is too thick to allow the "D" washer to
engage with the flat side of the spindle.
REMOVING THE BLADE
1. Unplug the sawn
i ./'_, WARNING: Failure to unplug the saw could result in accidental
! starting causing possible serious personal injury°
2. Raise the lower blade guard using the guard
handle, hold down the spindle lock button.
3. Follow Steps 1 through 4 on Mounting Blade to Saw.
4. Carefully remove blade.
i
Before attempting to use any tool, be sure to familiarize yourself with all the
operating features and safety instructions.
KNOW "{OUR SAW (See Fig. 2 )
"(our circular saw has many built-in convenience features for fast, efficient cutting These features
include the laser beam that projects a line of light along the cutting line for accurate cutting, it also
has easy-to-operate adjustments for depth-oFcut and bevel cutting
Electrical Connection
Your circular saw has a precision-built electric motor and it should only be connected to a 120-volt,
60-Hz, power supply (normal household current)° DO NOT operate on direct current (DC). This
large voltage drop will cause a loss of power that will overheat the motor,, If your saw does not
operate when plugged into an outlet, check the power supply°
Trigger Switch
To turn on the saw, squeeze the trigger switch, When you are finished sawing, release switch to
shut saw off. 13