To Use Outfeed Support; To Use The Table Extension - Craftsman 315.218060 Operator's Manual

TO USE OUTFEED SUPPORT
See Figure 31.
The ouLffeedsuopod slides to give the operator additional
support for cutting long workpieces.
m With the table saw in the OFF position, stand behind the
saw.
13 Grasp the outfeed suppod with both hands and pull it
ur_t_l it is _ulb]extended
TO USE THE TABLE EXTENSION
See Figure 32
Tile table extension provides the operator with additional
table width for supporting wider workpieces.
To e_;ter_d:
FJ Push the table extension lever beneath the saw table
rewards the back o_ the saw.
B Grasp the table extension with both hands al3d pull
it until the scale on the lront rail indicates the desired
measurement.
o Retighten the tab!e extension lever by pulling it towards
the front of the saw.
To close:
Push the table extension lever beneath the saw table
towards the back of the saw,
Q Push the table e/derision with both hands beck toward
the saw table.
Retighten the _able extension le,_e_ by pu_lle9 it towards
the front of the saw+
LOWER
SCALE
Fig. ;!1
LEVER
27
]
I