Support Long Workpieces - Craftsman 315.212040 Operator's Manual

10 in. compound miter saw double insulated
Hide thumbs

Advertisement

Table of Contents
Slowly lower the blade into and through the work-
piece. See Figure 29.
Release the switch trigger and allow the saw blade to
stop rotating before raising the blade out of workpiece.
Wait until the electric brake stops blade from turning
before removing the workpiece from miter table.
SUPPORT
LONG WORKPIECES
See Figure 31.
Long workpieces need extra supports. Supports should
be placed along the workpiece so it does not sag. The
support should let the workpiece
lay flat on the base
of the saw and work table during the cutting operation.
Use the optional work clamp or a C-clamp to secure the
workpiece.
,_
WARNING:
To avoid serious personal injury, always
keep your hands outside the no hands zone; at least
3 in. from blade. Never perform any cutting operation
freehand (without holding workpiece against the
fence). The blade could grab the workpiece
if it slips
or twists.
45°X 45° COMPOUND MITER CUT
Fig. 30
LONGWORKPIECE
WORKPIECE SUPPORTS
25
Fig. 31

Hide quick links:

Advertisement

Table of Contents
loading

  Related Manuals for Craftsman 315.212040