Table 12. Removal steps of HDD cover, HDD and HDD rubber rails or SSD and storage converter (continued)
Note: Mounted number of the hard disk drive depends on the models. In models with RAID features, two hard disk
drives that have same FRU no. must be used in slot 0 (
When installing: Make sure that the HDD connector or SSD connector is attached firmly.
HDD and HDD rubber rails:
When installing: The rubber rails on the hard disk drive must be attached to the replacement drive. Otherwise the
drive cannot be installed properly.
SSD and storage converter:
1050 DIMM slot cover and DIMM
For access, remove this FRU:
72
ThinkPad W700, W700ds, W701, and W701ds Hardware Maintenance Manual
a
) and in slot 1 (
3
a
b
5
b
).
4
5
5
6