Lenovo ThinkPad W700ds Hardware Maintenance Manual page 52

Table 2. Numeric error codes (continued)
Symptom or error
0196
Security hardware removed
0197
Invalid remote change requested.
0199
System Security— Security password retry count
exceeded.
01C8
Two or more modem devices are found. Remove all
but one of them. Press <Esc> to continue.
01C9
Two or more Ethernet devices are found. Remove all
but one of them. Press <Esc> to continue.
01C9
More than one Ethernet devices are found. Remove
one of them. Press <Esc> to continue.
01CA
More than one Wireless LAN devices are found.
Remove one of them.
0200
Hard disk error—The hard disk is not working.
021x
Keyboard error.
0220
Monitor type error—Monitor type does not match the
one specified in CMOS.
0230
Shadow RAM error—Shadow RAM fails at offset nnnn.
0231
System RAM error—System RAM fails at offset nnnn.
0232
Extended RAM error— Extended RAM fails at offset
nnnn.
0250
System battery error—System battery is dead.
0251
System CMOS checksum bad— Default configuration
used.
0252
Password checksum bad—The password is cleared.
46
ThinkPad W700, W700ds, W701, and W701ds Hardware Maintenance Manual
FRU or action, in sequence
1. Enter BIOS Setup Utility by entering supervisor
password, and select Password ➙ Security Chip ➙
Clear Security Chip to clear this error.
2. Security chip.
3. System board.
The remote configuration for the security chip has failed.
Confirm the operation and try again.
1. Run BIOS Setup Utility, and then save the current
setting by pressing F10.
2. System board.
1. Remove either a Mini-PCI Card or a modem daughter
card. Otherwise, press Esc to ignore the warning
message.
2. System board.
1. Remove either a Mini PCI Ethernet card or an
Ethernet daughter card. Otherwise, press Esc to
ignore the warning message.
2. System board.
1. Remove the Ethernet device that you installed; or
press Esc to ignore the warning message.
2. System board.
1. Remove the wireless LAN device that you installed.
2. System board.
1. Reseat the hard disk drive.
2. Load Setup Defaults in BIOS Setup Utility.
3. Hard disk drive.
4. System board.
Run interactive tests of the keyboard and the auxiliary
input device.
Load Setup Defaults in BIOS Setup Utility.
System board.
1. DIMM.
2. System board.
1. DIMM.
2. System board.
1. Charge the backup battery for more than 8 hours by
connecting the ac adapter.
2. Replace the backup battery and run BIOS Setup Utility
to reset the time and date.
1. Charge the backup battery for more than 8 hours by
connecting the ac adapter.
2. Replace the backup battery and run BIOS Setup Utility
to reset the time and date.
Reset the password by running BIOS Setup Utility.