Oki GL408e Install Manual page 5

GL4xxe Label Cutter Installation
The Label Cutter is housed in a cover assembly that is designed to replace the
factory-installed front cover of the GL4xxe series printer. Follow the procedures
below to install the Label Cutter.
1. Make sure the printer is OFF and disconnected from the power supply.
2. Lift up the side cover to access the original housing cover (1).
3. Remove the housing cover by unscrewing the thumbscrew (2) at the
side of the printer.
4. Affix the Label Cutter (3) to the printer by plugging the white connector
(4) into the complementary connector (5) on the printer.
5. Locate the thumbscrew removed in Step 3 above, and screw it back into
place to secure the Label Cutter. Note: Ensure that the cable is not
pinched when you install the label cutter cover in place.
6. Restore power to the Printer and configure the printer to use the cutter.
(See next page)
7. Perform a test print and ensure that the label cutting process is correct.
4
3
Figure 1. Preparing and installing the Simple Cutter
Simple-Cutter Installation Guide
5
3
5
1
2