Connecting Pioneer Changers - Escient FireBall E-120 Installation And User Manual

Connecting Pioneer Changers

u
Use an RS-232 cable (not supplied with FireBall) with connectors made
specifically so that one end connector fits the pin configuration for FireBall and
the other end connector fits the pin configuration for your specific CD changer.
Refer to Appendix A for the pin configurations.
v
Insert one end of the cable (the FireBall connector end) into an RS-232 COM
port on FireBall. There are 3 available COM ports.
w
Insert the other end of the cable (the connector that fits the CD Changer) into the
RS-232 port on the CD Changer.
x
To connect additional CD changers, repeat steps 1 through 3 using the other
COM ports.
y
Connect audio from each CD Changer to FireBall. Connections using optical
cables to the digital ports will produce the highest quality audio.
z
Make sure the changer is powered on.
F B I & U ' G
IRE ALL NSTALLATION SER S UIDE
2
Refer to Appendix A for cable pin-
out configurations.
2
When connecting digital audio
inputs to FireBall, make sure
Digital Audio 1 is from Changer
1, Digital Audio 2 is from
Changer 2, and Digital Audio 3 is
from Changer 3.
C 2 - S
HAPTER
- M22001-01A1
U F B
ETTING P IRE ALL
P 37
AGE