Checking The Codes - Escient FireBall E-120 Installation And User Manual

substitute the appropriate key (i.e., AUX, CBL, DVD, RCV) for the (Auxiliary, VCR,
Cable, Satellite, CD, Amplifier, or Tuner) component you are searching for.

Checking the Codes

If you have set up the Remote using the Searching For Your Code procedure, you may
need to find out which four-digit code is operating your equipment.
For example, to find out which code is operating your TV:
1. On the Remote, press TV once.
2. Press and hold CODE SET until the LED blinks twice, then release CODE SET .
3. Enter 9 - 9 - 0. The LED will blink twice.
4. To view the code for the first digit, press 1 once. Wait 3 seconds, count the LED
blinks (e.g., 3 blinks = 3) NOTE: If a code digit is "0", the LED will not blink.
5. Repeat step 4 three more times for remaining digits. Use 2 for the second digit, 3 for
the third digit, and 4 for the fourth digit.
6. To check for the codes of your other components, repeat steps 1 through 5, but
substitute the appropriate key (i.e., AUX, CBL, DVD, RCV) component you are
checking. As before, write down each four-digit code.
F B I & U ' G
IRE ALL NSTALLATION SER S UIDE
A H - R
PPENDIX
- M22001-01A1
C
EMOTE ONTROL
P 208
AGE