Single-Phase Ac Cabling For Usa; Connecting The Power-Supply Cords - HP StorageWorks XP1024 Manual

Single-phase AC cabling for USA

Connecting the power-supply cords

Preparing for installation
When configured for 40/50-amp, single-phase power, each HP Disk Array
XP1024 cabinet (both the 50-amp DKC and the 40-amp DKUs) has two
power cords and two main disconnect devices so that AC power can be
supplied from separate power distribution panels. When configured for
30-amp, single-phase power, each HP Disk Array XP1024 cabinet has four
power cords and four main disconnect devices.
Warning
Trained service personnel should be present whenever the disk array is
being connected to a new power source for the first time. Incorrect power
connections can cause equipment damage and possible injury or death to
personnel.
If you intend to use HP Disk Array XP512 DKUs with your HP XP1024
Disk Array, see the HP StorageWorks Disk Array XP512 Site Preparation
Guide for cabling information for these DKUs.
The HP Disk Array XP1024 can be factory-configured for 40/50-amp or
30-amp, single-phase power.
61