HP Surestore 64 - Director Switch User Manual page 260

Message
Cannot run diagnostics on an
uninstalled port.
Cannot run diagnostics while a
device is logged-in to the port.
Cannot save port configuration.
Cannot save SNMP
configuration.
Cannot set Fibre Channel
parameters.
Cannot set director date and
time.
Cannot set director state.
Cannot set write authorization
without defining a community
name.
Cannot start data collection.
Cannot start firmware install
while CTP synchronization is in
progress.
Cannot start port diagnostics.
Click to remove all contents
from log.
244
Cause/Solution
Port diagnostics cannot be performed on a port that is not
installed. Run diagnostics only on a port that is installed.
A device is logged in to the port where a diagnostic test is
attempted. Log out the device and run the diagnostic test again.
Port configuration cannot be saved. The link is down or busy.
Retry the operation later. If the condition persists, contact
support personnel.
SNMP configuration cannot be saved. The link is down or busy.
Retry the operation later. If the condition persists, contact
support personnel.
Fibre Channel parameters cannot be set. The link is down or
busy. Retry the operation later. If the condition persists, contact
support personnel.
Director date and time cannot be set. The link is down or busy.
Retry the operation later. If the condition persists, contact
support personnel.
Director state cannot be set. The link is down or busy. Retry the
operation later. If the condition persists, contact support
personnel.
A community name was not defined in the Configure SNMP
dialog box for the write authorization selected. Provide a name
in the name field where write authorization is checked.
Data collection cannot be started. The link is down or busy.
Retry the operation later. If the condition persists, contact
support personnel.
CTP synchronization is in progress while you are attempting to
install firmware. Wait for the CTP synchronization to complete
before starting the firmware install.
Port diagnostics cannot be started. The link is down or busy.
Retry the operation later. If the condition persists, contact
support personnel.
Requesting confirmation that you want all contents removed
from the log. Click to continue or click
operation.
to end the