Generic Traps; Cold Start - HP Surestore 64 - Director Switch Manual

Threshold Alert Group
Table 2-29
Variable
ef6000TAIndex
ef6000TAName
ef6000TAState
ef6000TAType
ef6000TAPortType
ef6000TAPortList
ef6000TAInterval
ef6000TATrggerValue
ef6000TTADirection
ef6000TTATriggerDuration
ef6000CTACounter

Generic Traps

The following generic traps can be received from the director:
• coldStart
Reports that the SNMP agent is reinitializing due to a power-on reset.
Threshold Alerts Table
Provides:
This object is used to identify which threshold has been triggered.
The threshold alert name.
The current state of the threshold (enabled=1, disabled=2).
The type of the threshold. (throughput=1, counter=2)
A threshold can be set on a list of physical port numbers or on all the ports of
the specified type (list=1, ePorts=2, fPorts=3, flPorts=4)
A bitmap that identifies which ports this threshold alert applies to (only valid
when the threshold alert port type = list). The left-most bit represents port 0.
The number of minutes in a threshold alert interval.
If the alert type is a Throughput Thrreshold Alert, this is the percent of utilization
(1-100) required to trigger an alert. If the alert type is a Counter Threshold Alert,
this is the counger delta required to trigger an alert.
Specifies the throughput direction of the threshold (transmit=1, receive=2,
either=3). This only applies when the alert type is Throughput Thrreshold Alert.
Specifies the amount of timeduring a threshold alert interval that the trigger
must be exceeded before an alert is generated. This only applies when the alert
type is Throughput Thrreshold Alert.
Specifies statistical counter or counter set to be monitored. This object is not
supported in the current release.
49