HP StorageWorks XP20000/XP24000 - Disk Array Reference Manual page 16

Item Description
Allows you to add, delete or change SNMP system group information. If system group
information has already been registered, the registered information displays. To register the
system group information, the Extension SNMP check box must be selected. When you register
system group information, select Apply. System group information is as follows:
Name: Connected storage system name. Remote Web Console users can change the
device name. You can use up to 180 alphanumeric characters for a device name. You
cannot use the following: ", \, ;, :, ,, *, ?, <, >, |, /, ^, &, %, . You can use a space in
the middle of the device name, but not before and after and a space before or after the
device name.
The device name is required to use SNMP Agent. Make sure to document the device name,
because settings will be cleared when SVP is replaced.
Contact: Contact information such as personnel and telephone numbers where you can
inquire about the connected storage system. Remote Web Console users can change
System Group
contact information in Modify mode. Enter contact information using up to 180 alphanu-
meric characters (ASCII codes), except for some symbols, such as ", \, ;, :, ,, *, ?, <, >,
|, /, ^, &, and %. You can also use a space, except before and after contact information.
A contact name is required to use SNMP Agent. Make sure to document the contact name,
because settings will be cleared when SVP is replaced.
Location: Location of connected storage system. Remote Web Console users can change
device locations with the modify mode. You must enter a device location using up to 180
alphanumeric characters (ASCII codes). You can use a space, except for before and after
the location. You cannot use some symbols, such as ", \, ;, :, ,, *, ?, <, >, |, /, ^, &, and
%.
The device location is required to use SNMP Agent. Make sure to document the device
location, because the settings will be cleared when SVP is replaced.
Executes test report of the trap to the community registered in the disk storage system.
Trap Test Operation in Modify mode is required to use this button. Operation authority is required as
well.
Apply Implements settings made on this window.
Cancel Cancels settings made on this window.
16 Using the SNMP GUI