Symptom-To-Fru Index; Numeric Error Codes - Lenovo ThinkPad Edge 15 Hardware Maintenance Manual

Hardware maintenance manual
Hide thumbs Also See for ThinkPad Edge 15:
Table of Contents

Advertisement

2. Click the triangle mark on the right side of the Shut down icon; then select Hibernate.
To return from hibernation mode, press the power button for more than 4 seconds.

Symptom-to-FRU index

This section contains following information:
"Numeric error codes" on page 43
"Error messages" on page 45
"No-beep symptoms" on page 46
"LCD-related symptoms" on page 46
"Intermittent problems" on page 46
"Undetermined problems" on page 47
The symptom-to-FRU index in this section lists symptoms and errors and their possible causes. The most
likely cause is listed first, in boldface type.
Note: Do the FRU replacement or other actions in the sequence shown in the column headed "FRU or
action, in sequence." If replacing a FRU does not solve the problem, put the original part back in the
computer. Do not replace a nondefective FRU.
This index can also help you determine, during regular servicing, what FRUs are likely to need to be
replaced next.
A numeric error is displayed for each error detected in POST or system operation. In the displays, n can
be any number.
If no numeric code is displayed, check the narrative descriptions of symptoms. If the symptom is not
described there, go to "Intermittent problems" on page 46.
Note: For a device not supported by diagnostic codes in the ThinkPad Notebooks, see the manual for
that device.

Numeric error codes

Table 2. Numeric error codes
Symptom or error (beeps, if any)
0187
EAIA data access error—The access to EEPROM is failed.
(two short beeps)
0189
Invalid RFID configuration information area—The
EEPROM checksum is not correct.
(two short beeps)
0190
Critical low-battery error
(two short beeps)
0191
System Security—Invalid Remote Change requested.
0210
Stuck Key
(two short beeps)
FRU or action, in sequence
System board.
System board.
1. Charge the battery pack.
2. Battery pack.
1. Run BIOS Setup Utility, and then save current
setting by pressing F10.
2. System board.
Change keyboard, and restart the computer.
Chapter 4
.
Related service information
43

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents