Fibre Address; Fabric And Connection Parameter Settings; Installing And Configuring The Host; Loading The Operating System And Software - HP StorageWorks XP10000 - Disk Array Configuration Manual

Xp disk array configuration guide for sun solaris
Hide thumbs Also See for StorageWorks XP10000 - Disk Array:
Table of Contents

Advertisement

Fibre address

In fabric environments, the port addresses are assigned automatically. In arbitrated loop environments,
set the port addresses by selecting a unique arbitrated loop physical address (AL-PA) or loop ID for
each port. For specific values, refer to the HP StorageWorks XP LUN Manager User's Guide applicable
to your array.

Fabric and connection parameter settings

Set each array port to FABRIC ON or OFF with connections of POINT-TO-POINT or FC-AL as shown
in the following table and figures. For detailed topology information, refer to the HP StorageWorks
SAN Design Reference Guide at:
http://www.hp.com/go/sandesign
Figure 2 Point-to-point fabric topology example
.
Table 2 Fabric topology settings
Fabric parameter
ON
OFF
ON
OFF

Installing and configuring the host

This section explains how to install and configure Fibre Channel adapter (FCA) that connect the host
to the disk array.

Loading the operating system and software

Follow the manufacturer's instructions to load the operating system and software onto the host. Load
all OS patches and configuration utilities supported by HP and the FCA manufacturer.
Connection parameter
FC-AL
FC-AL
POINT-TO-POINT
POINT-TO-POINT
XP Disk Array Configuration Guide for Sun Solaris
Provides
Legacy support only (FL-port (public loop) for
loop connection to a switch)
NL-port (private arbitrated loop) for direct
connect
F-port (fabric port) for connection to a switch
Not supported
13

Advertisement

Table of Contents
loading

Table of Contents