Setting The System Option Modes; Configuring The Fibre Channel Ports; Host Group Modes (Options) - HP StorageWorks XP10000 - Disk Array Configuration Manual
Xp disk array configuration guide for sun solaris
Hide thumbs
Also See for StorageWorks XP10000 - Disk Array:
- User manual (92 pages) ,
- Owner's manual (92 pages) ,
- Site preparation manual (80 pages)
Table of Contents
Advertisement
The following host group modes (options) are available for Solaris:
Table 1 Host group modes (options)
Host
Group
Mode
Function
Veritas DBE+RAC Database Edition/Ad-
vanced Cluster for Real Application Clusters
2
or if Veritas Cluster Server 4.0 or later with
I/O fencing function is used.
7
Reporting Unit Attention when adding LUN
CAUTION:
Changing host group modes for ports where servers are already installed and configured is disruptive
and requires the server to be rebooted.
Setting the system option modes
The HP service representative sets the system option mode(s) based on the operating system and
software configuration of the host. Notify your HP representative if you install storage agnostic software
(such as backup or cluster software) that may require specific settings.
Configuring the Fibre Channel ports
Configure the disk array Fibre Channel ports by using XP Remote Web Console (shown) or XP
Command View Advanced Edition Software. Select the settings for each port based on your storage
area network topology. Use switch zoning if you connect different types of hosts to the array through
the same switch.
12
Installing and configuring Sun Solaris for the XP disk array
Default
Comments
Previously MODE186
Inactive
Do not apply this option
to Sun Cluster.
Previously MODE249
Inactive
Advertisement
Table of Contents
