The Machine Is Not Displayed (Detected) On The Detected Printers List Screen - Canon PIXMA MP495 Network Setup Manual

Glossary
• IP address
A numerical identification assigned to each computer or network device connected to a network.
• DHCP function
A function to automatically assign required information (IP address, etc.) to computers, printers or other
devices connected to the network.
• Subnet mask
A number used to distinguish the network and host portions of an IP address.
• Default gateway
A device required to connect to external networks.
The Machine is Not Displayed (Detected) on the Detected Printers List
Screen
Check
Check 1
Make sure that you follow Check 1, 2, 3, 4 and 6 of "Connection Checklist" on page 11,
then click Redetect.
Check 2
Is the machine connected to a network?
• To check if the machine is connected to a network, print the Network
Configuration Page, then make sure that Link Status is set to Active. To print
the Network Configuration Page, press the Maintenance button 11 times to
display the screen shown to the right, then press the Black button or the Color
button.
If the machine is not connected to a network, perform setup again by following the
procedures from "6 Set Up a Wireless Connection" in the printed manual: Getting
Started.
Check 3
Is the IP filtering feature enabled on the access point?
• For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
Set the access point to accept the IP address of the machine.
• For details on how to change the settings of the access point, refer to the manual
supplied with the access point or contact its manufacturer.
• To check the IP address of the machine, print the Network Configuration Page,
then check IP Address. To print the Network Configuration Page, press the
Maintenance button 11 times to display the screen shown to the right, then press
the Black button or the Color button.
Check 4
When obtaining an IP address automatically, make sure that the DHCP function of the
access point is active.
• For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
Enable the DHCP function of the access point, then click Redetect.
• For details on how to change the settings of the access point, refer to the manual supplied with
the access point or contact its manufacturer.
Check 5
Is the privacy separator feature enabled on the access point?
• For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
Disable the privacy separator feature.
• For details on how to change the settings of the access point, refer to the manual supplied with
the access point or contact its manufacturer.