Problems During Network Setup; Wps; E > 2 > 0" Is Displayed; E > 2 > 3" Is Displayed - Canon PIXMA MP495 Network Setup Manual

Glossary
• IP address
A numerical identification assigned to each computer or network device connected to a network.
• IP address filtering
A function to allow or block traffic from network devices with specified IP addresses.
• DHCP function
A function to automatically assign required information (IP address, etc.) to computers, printers or other
devices connected to the network.
• Privacy separator feature
A function to prevent communication between multiple wireless devices (such as computers and
printers) connected to an access point.

Problems during Network Setup

WPS

"E > 2 > 0" is Displayed
Action
The error appears when attempting to configure LAN
settings of the machine from the Operation Panel while
they are being configured in another way. Configure the
settings after completing the settings.
"E > 2 > 3" is Displayed
Action
The message appears when multiple access points are
detected.
Wait for a while, then configure the settings again.
"E > 2 > 4" is Displayed
Check
The message appears when an error occurs.
Check the access point settings, then configure WPS
settings again.
• For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
• For the procedure to configure WPS settings of the machine, refer to "Wireless Setup Using WPS
(Wi-Fi Protected Setup)" in the printed manual: Getting Started.
• When using an access point that does not support WPS, configure the settings by referring to "6
Set Up a Wireless Connection" in the printed manual: Getting Started.