Setting The Clock - Frigidaire PLCF489GC - 40 Inch Dual Fuel Range User Manual

Setting the Clock

The pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
Clock
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
time in the display will flash (See Figure 1).
INSTRUCTIONS
To set the clock (example below for 1:30)
1. Press . "CLO" will appear in the display (Figure 2).
Clock
2. Press
1 3 0
"CLO" will stay in the display. Press
and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1. Press and hold
Clock
"12h" (Figure 5) or "24h" (Figure 6) will appear in the display and
the control will beep once.
2. Press to switch between the 12 and 24 hour time of day
Clean
display. The display will show either "12h" (Figure 5) or "24h"
(Figure 6).
3. Press to accept the change or press
START
change.
4. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.
pads to set the time of day to 1:30 (Figure 3).
. "CLO" will disappear
START
for 7 seconds (Figure 3). After 7 seconds,
Clear
to reject the
/Off
2
TIMED
DOOR
PRESS
Clock
1 3
0
TIMED
DOOR
START
TIMED
DOOR
for 7 seconds
Clock
TIMED
DOOR
Clean
Clear
or
START
/Off
DELAY TIMER CONV BAKE BROIL
LOCKED CLEAN ROAST WARM PROBE
Figure 1
DISPLAY
DELAY TIMER CONV BAKE BROIL
LOCKED CLEAN ROAST WARM PROBE
Figure 2
DELAY TIMER CONV BAKE BROIL
LOCKED
CLEAN ROAST WARM PROBE
Figure 3
DELAY TIMER CONV BAKE BROIL
LOCKED CLEAN ROAST WARM PROBE
Figure 4
Figure 5
Figure 6