Adding Standard Filter-Based Monitors; Telnet Commands To Add Filter-Based Monitors - HP StorageWorks MSA 2/8 - SAN Switch User Manual

Using Advanced Performance Monitoring

Adding Standard Filter-Based Monitors

This section describes how to add standard filter-based monitors to a port. Use the
telnet commands listed in
Table 4: Telnet Commands to Add Filter-based Monitors
perfAddReadMonitor
perfAddWriteMonitor
perfAddRWMonitor
perfAddSCSIMonitor
perfAddIPMonitor
Example. These commands add several filter-based monitors to port 2 and display
the results.
46
Telnet Command
sw1:admin> perfAddReadMonitor 2
SCSI Read filter monitor #0 added
sw1:admin> perfAddWriteMonitor 2
SCSI Write filter monitor #1 added
sw1:admin> perfAddRWMonitor 2
SCSI Read/Write filter monitor #2 added
sw1:admin> perfAddSCSIMonitor 2
SCSI traffic frame monitor #3 added
sw1:admin> perfAddIPMonitor 2
IP traffic frame monitor #4 added
sw1:admin> perfShowFilterMonitor 2
There are 5 filter-based monitors defined on port 2.
KEY ALIAS OWNER_APP
-------------------------------------------------------------
0 SCSI Read TELNET
1 SCSI Write TELNET
2 SCSI R/W TELNET
3 SCSI Frame TELNET
4 IP Frame TELNET
Advanced Performance Monitoring Version 3.1.x/4.1.x User Guide
Table 4 to define filter-based monitors on a port.
Count the number of SCSI Read
commands
Count the number of SCSI Write
commands
Count the number of SCSI Read and
Write commands
Count the number of SCSI traffic frames
Count the number of IP traffic frames
OWNER_IP_ADDR
Description
FRAME_COUNT
N/A 0x0000000000000000
N/A 0x0000000000000000
N/A 0x0000000000000000
N/A 0x0000000000000000
N/A 0x0000000000000000