Panasonic Lumix DMC-GH2K Operating Instructions Manual page 17

Before Use
There are 2 ways to operate the rear dial, rotating left or right, and deciding by pressing.
Rotating:
Selection of items or setting of values is performed during the various settings.
Pressing:
Operations that are the same as [MENU/SET] button, such as selection of settings
and exiting the menu, are performed during the various settings.
• Rear dial is described as follows in these operating instructions.
e.g.: Rotating left or right e.g.: Pressing the rear dial
At the time of purchase, [INTELLIGENT AUTO] is assigned to the
[Fnl] button, [FILM MODE] to the • (Fn2) button and
[METERING MODE] to the • (Fn3) button.
• The functions to be assigned can be selected from the menu below
using [Fn BUTTON SET] in the [CUSTOM] menu.
[REC] menu/Recording functions [CUSTOM]menu
[INTELLIGENT AUTO]/[FILM MODE]/ [GUIDE LINE]/[SHUTTER AF]/
[FOCUS AREA SET]/[ASPECT RATIO]/[QUALITY]/ [PRE AF]/[ _ REC AREA]
[1 SHOT RAW_-*=,]/[METERING MODE]l[1 SHOT []]/
[FLASH]/[FLASH ADJUST.]/[ISO LIMIT SET]/
[EX. TELL CONV.]/[BURST RATE]/
[AUTO BRACKET]
• Refer to Pl17 for details about [REC] Mode menu.
• Refer to P129 for details about [CUSTOM] menu.
• When [INTELLIGENT AUTO] is set, pushing the button will switch to intelligent Auto Mode.
(Pressing the button again or turning off the camera will cancel the setting.)
• When set to [FOCUS AREA SET], it is possible to display the position setting screen of either
AF area or MF Assist.
•When [1 SHOT RAWs_-_] is set, it will record the RAW file and a fine JPEG image simultaneously
once only. It will return to original quality after recording.
• When [1 SHOT [ZL]] is set, it will record with [METERING MODE] set to [EB] (spot) once only. It
will return to original Metering Mode after recording.
VQT3A36
17