Panasonic KX-F900 Service Manual page 41

- KX-F900 .....
(2) Communication error functions
(_ Operation:
1. Press the MENU button 3 times.
2. Press the START/SET button and v button 4 times.
3. Press the START/SET button.
4. Print out.
(_ Error code table:
CODE RESULT MODE SYMPTOM Counter-
measure
PRESSED THE STOP KEY
DOCUMENT JAMMED
NO DOCUMENT
PRINTER OVERHEATED
PAPER OUT
THE COVER WAS OPENED
PAPER JAMMED
NO RESPONSE
41 COMMUNICATION ERROR
42 COMMUNICATION ERROR
43 COMMUNICATION ERROR
44 COMMUNICATION ERROR
46 COMMUNICATION ERROR
48 COMMUNICATION ERROR
49 COMMUNICATION ERROR
50 COMMUNICATION ERROR
51 COMMUNICATION ERROR
NO RESPONSE
53 COMMUNICATION ERROR
54 COMMUNICATION ERROR
57 COMMUNICATION ERROR
58 COMMUNICATION ERROR
59 COMMUNICATION ERROR
64 COMMUNICATION ERROR
68 COMMUNICATION ERROR
70 COMMUNICATION ERROR
72 COMMUNICATION ERROR
FF COMMUNICATION ERROR
TX& RX
TX
TX
RX
RX
TX & RX
Communication was interrupted with the STOP button
Document paper is jammed
No document paper
Thermal head is overheated
Out of thermal paper
Cover is open
RX
TX
TX
TX
TX
TX
RX
RX
RX
RX
RX
RX
TX
RX
TX
RX
TX
TX
RX
RX
RX
TX& RX
Recording paper is jammed
Transmission is finished when T1 TIMER is expired 1
DCN is received after DCS transmission 2
FTT is received after transmission of 2400BSP training signal 3
No response after post message is transmitted three times 4
RTN and PIN are received 5
No response after FTT is transmitted 6
No post message 7
RTN is transmitted 8
PIN is transmitted (to PRI-Q) 8
PIN is transmitted 8
Reception is finished when T1 TIME is expired 9
DCN is received after transmission of NSC and DTC 10
DCN is received after DIS transmission 11
300BPS error 12
DCN is received after FTT transmission 13
DCN responds to post message 14
Polling is not possible 15
No response at the other party after MCF or CFR is transmitted 13
DCN is received after CFR transmission 13
Carrier is cut when image signal is received 16
Modem error 12
1
' --I
TX=TRANSMISSION RX=RECEPTION
-41 -