Panasonic KX-F900 Service Manual page 150

KX-F900
Bit No.
24
25
26
27
I
DIS/DTC
Extend field
2400 bitJs handshaking
Uncompressed mode
Error correction mode
28 Set to "0"
Standard setting.......... Dcs ..........
1
0
0
0
0
29 Error limiting mode 0
30 Reserved for G4 capability on PSTN 0
31 Unassigned 0
32 Extend field 1
Validity of bits 17,18
Bits 17,18 are valid
Bits 17,18 are invalid
33
(0)
(1)
0
Extend field
2400 bitJs handshaking
Uncompressed mode
Error correction mode
Frame size 0 = 256 octets
1 = 64 octets
Error limiting mode
Reserved for G4 capability on PSTN
34 Recording width capability 1216 picture elements 0
along scan line length of 151 mm __.1%
35 Recording width capability 864 picture elements 0
along scan line length of 107 mm 4- 1%
36 Recording width capability 1728 picture elements 0
along scan line Jength of 151 mm 4- 1%
37 Recording width capability 1728 picture elements 0 Invalid
along scan line length of 107 mm 4- 1%
38 Reserved for future recording width capability 0
39 Reserved for future recording width capability 0
40 Extend field 1 Extend field
41 Semi super time / mm 1
42 Semi super time / inch 0
43 Super time 0
44 inch 0
45 mm 1
46 MSC/SF 0
47 Select polling 0
48 EXT 0
Note 1 - Standard facsimile units conforming to T.2 must have the following capability : Index of cooperation (IOC)=264.
Note 2 - Standard facsimile units conforming to T.3 must have the following capability : Index of cooperation (IOC)=264.
Note 1 - Standard facsimile units conforming to T.4 must have the following capability : Paper length=297 mm.
Signal IdentificationSignalFormat Function
Training 1
Extend field
Recording width
Recording width indicated by bits 17,18
Recording width indicated by this field bit
information
Middle 1216 elements of 1728 picture
elements
Middle 864 elements of 1728 picture
elements
Invalid
TCF
(Training Check)
CFR
(Confirmation to Receive)
Training 2
X0100001
Fixed pattern is transmitted to receiving side at speed
(2400 to 9600 bps) designated by DCS, and the receiving side
optimizes the automatic equalizer, etc., according to this signal.
Sends 0 continuously for 1.5 seconds at the same speed as the
training signal.
Notifies sending side that TCF has been properly received. If
TCF is not properly received, FTT (Failure To Train) X0100010
is relayed to sender. Sender then reduces transmission speed
by one stage and initiates training once again.
Used for reconfirmation of receiving side the same as training 1
-- 150-