Operatingperipheralequipmentusing The Remote Control - Panasonic CT-34WX50 Operating Instructions Manual

Operating peripheral equipment using the remote control
TV/VlOC-O
2. Setting to the remote using the step and set method
(When the code is not known):
+
Press and hold the POWER and
ACTION keys simultaneously for three
full seconds.
After 3 seconds, all the illuminated mode
keys will begin to flash.
Release the POWER and ACTION key.
CH
VOL _ VOL
CH
2 <_ _ Press the mode key.
The mode key will illuminate steadily,
all others will go out.
CH
VOL VOL
CH
Press VOL" D "key to step to the next
code.
Press POWER to send a test signal in
that format.
Continue doing this until the proper
device code is found, and the target
device responds.
Once the code has been found, press
the ACTION key to lock it in.
Notes:
• The step and set mode will start from the current device (not the beginning of the list,
except for the first time).
• The step and set mode works in the reverse direction using the VOL" <_" key.
Infrared Remote Codes for Specific Components
Helpful Hint: Write down the code numbers for your components in the space provided below. This will serve as a
hand)/'reference whenever you need to reprogram ),our remote control.
CABLE
oa_,eBox I I II
DBS
I I I I
Other Component
I I I
Other Component
VCR
Video Cassette Recorder I I I
RCVR
Receiver or Amplifier I I I
I I I
Other Component
LI I
Other Component
CD
CompaotOiooP,ayer I I I I
LD
•aserO,ooP,ayer I I I I
I I I
OthorCompooon, I I I
Other Component
62