Panasonic CT-34WX50 Operating Instructions Manual page 23

ASPECT Controls
mode Picture Explanation
Panasonic
AUTO
NORMAL
ZOOM
FULL
JUST
For an elongated image
P,_- 4 ----_
For a 4:3 image
Image is expanded
Changes in accordance
.__ with the Panasonic
AUTO mode setting
(Refer to page 24)
_ 4 "_-I _16_
o©o ! .
o o I i[
I,---.-.- 4 .----_ _16--------N
I----_- 4 _ I--_-----16_
The display will automatically become enlarged
(depending on the picture source), allowing you to view
the picture at its maximum size.
Note:
(1) Panasonic Auto Mode is designed to automatically
adjust the aspect ratio to handle a mix of 16:9 and
4:3 program material. Certain 4:3 program material,
such as stock market data screens, may
occasionally cause the image size to change
unexpectedly. When viewing such programming, it
is recommended that the ASPECT be set to
NORMAL.
(2) There may be a slight delay for the screen size to
adjust. If a 480p or 1080i signal is input during
component input signal mode, the controls will not
operate.
NORMAL will display a 4:3 picture at its standard 4:3
size.
ZOOM mode magnifies the central section of the picture.
FULL will display the picture at its maximum size but
with sight elongation.
JUST mode will display a 4:3 picture at maximum size
but with aspect correction applied to the center of the
screen so that elongation is only apparent at the left
and right edges of the screen. The size of the picture
will depend on the original signal.
Notes:
(1) The S-VIDEO terminal on this set can detect specially encoded signals that are compatible with a wide screen monitor.
When a full image from the S-VIDEO terminal of specially encoded video is detected by the set, the screen size is
automatically set to FULL mode.
(2) The screen size also changes if ID-1 is detected.
(3) The screen size will also change if $1 detection has been set.
25