Equator EZ 2500 C Service Manual And Spare Parts List page 6

Problem Possible Cause
5. Noisy 5a. Not leveled.
5b. Foreign object in tub.
5c. Shock Absorber.
6. Vibrates. 6a. Shipping brackets attached.
6b. Unstable floor
6c. Not leveled properly
7. Water leaks 7a. Not leveled.
from detergent
drawer
7b. Spinning with water in tub.
7c. Electronic Control Module
7d. Motor (tachometer).
8. Timer doesn't 8a. Water supply off.
advance
8b. Filling interrupted.
8c. Timer.
9. Tub rotates 9a. Electronic Control Module
one direction only
during wash and
dry cycles
9b. Timer.
10. Water flows 10a. Water inlet valves leaking.
into tub with
machine off.
Repair Procedure
5a. Adjust levelling legs, tighten lock nuts.
5b. Check tub, remove object.
5c. Check that attachment bolts are tight.
6a. Remove & store shipping brackets.
6b. Remove carpeting, move to abeter location,
or install underlayment.
6c. Adjust levelling legs, tighten lock nuts.
7a. Adjust levelling legs, tighten lock nuts.
7b. Not draining. See Won't drain
7c. Test signals at Control Module. See Testing
Electronic Control. If correct, replace control
module. If tests between terminals 1-7 fail,
replace timer. If tests on terminals 8, 9 or 12-15
fail, replace motor.
7d. Check tachometer resistance. See Testing
the Drive Motor.
8a. Check water pressure at inlet valve
connections.
8b. See Won't Fill.
8c. Test timer motor resistance: 2000 ohms
max. Set to different cycle (e.g. Delicates) &
check timer function different cycle (e.g.
Delicates).
9a. Test signals at Control Module. See Testing
Electronic Control. If correct, replace control
module. If tests between terminals 1-7 fail,
replace timer. If tests on terminals 8, 9 or 12-15
fail, replace motor.
9b. See above.
10a. Identify leaking valve. Remove and clean
by backflushing to remove foreign material.
Replace valve if cleaning does not correct the
problem.
4