Equator EZ 2500 C Service Manual And Spare Parts List page 5

Problem Possible Cause
1g. Timer
1h. Temperature Selector Switch
1i. Water inlet valves.
2. Fills, won't
2a. Belt.
agitate
2b. Electronic Control Module
2c. Motor
3. Won't drain 3a. Filter
3b. Drain hose
3c. Drain
3d. Pump
3e. Timer
4. Won't spin. 4a. Belt.
4b. Electronic Control Module
4c. Overloaded
4d. Wet load
Repair Procedure
1g. Set to start of regular wash cycle. Test for
115 vac between high side of hot and cold water
inlet valves and common (low) side of water
inlet valves. If not present, the timer may be
defective.
1h. Set to Start of the regular wash cycle. Set
water temperature selector to WARM/COLD.
Test for 115 vac between high side of hot and
cold water inlet valves and common (low) side
of water inlet valves. If not present the selector
switch may be defective .
1i. If 115 vac is present across a water inlet
valve coil and water pressure is present, the
machine should fill. If not, the valve may be
defective.
2a. Check belt, adjust tension.
2b. Test signals at the Control Module. See
Testing the Electronic Control Module. If correct,
replace the Control. If test on terminals 1 to 7
fail, replace timer. If tests on terminal 8, 9, 12
through 15 fail, replace motor.
2c. Check motor resistance. See Testing Drive
motor.
3a. Remove, clean, and replace filter.
3b. Check for kinks or blockage.
3c. Drain standpipe inlet more than 36" above
the floor. Blocked drain. (direct connection)
3d. With power off, run pump cooling impeller
manually to check for jamming. If pump does
not turn freely, disassemble, remove foreign
objects, and reassemble.
3e. Set timer to REGULAR SPIN. Test for 115
vac across the pump terminals. If present, the
pump may be defective. If not present, timer
may be defective.
4a. Check belt, adjust tension.
4b. Test Control Module in accordance with the
appropriate procedure.
4c. Reduce load size.
4d. Check water inlet valves for leaks. See #3
3