Unpackthe Pressure Washer; Attach Handle And Cleaning Tank; Carton Contents - Craftsman 580.752120 Operator's Manual

Your c leaning system requires some assembIy andisready
foruse onlyafter i t hasbeen properiy serviced withthe
recommended oilandfuel.
Jf
you have any prohbms with the assembly of your
pressurewasher, please call the pressurewasher hempJine
at 1o800o222o3136.
UNPACKTHE PRESSURE WASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTONCONTENTS
Checkali contents, if any parts are missing or damaged, call
the pressure washer hetpline at 1o800o222o3136.
° Main Unit
° Handle
, 6baning Tank Assembly
, High Pressure Hose
, Spray Gun
, Nozzb Extensionwith Quick Connect Fitting and Spray
Tip
Holder
, Oil Bottle
, Parts Bag (which includes the following):
, Operator's Manual
, Owner's Registration Card
, Safety Goggles
, Gun Holder Wireform
, DetergentSiphoning Hose/Filter
° Bagcontaining 4 multi-coiored Spray Tips
, HandleFasteningHardwareKit (which includes):
, Carriage Bolts (2)
, "L" Bolt
° Plastic Knobs (4)
, Tree Clips (4}
Becomefamiliar with each piece before assembling the
pressure washer, identify ali contents with the iiiustration on
page 6. if any parts are missing or damaged, calJthe
pressure washer helpline at 1o800o222o3136.
A$$EJVJBLJNG CLEANING SYSTEJVJ
Your Craftsman cleaning system will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle and cleaning tank.
3. Connect detergent siphon hose to pump.
4. Add eli to engine crankcase.
5. Add fuei to fuel tank.
6. Connect pressure hose to spray gun and pump.
7. Connectwater supply to pump.
8. Attach nozzleextension to spray gun.
9. Select/attach quick connect spray tip to nozzb extension.
Attach Handle and Cleaning Tank
1. Placehandle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with holes
(g) on handle supports.
NOTE:It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handb supports.
2. Insert carriage bolts (A) through holes from back of unit
and attach a plastic knob (B) from front of unit. Tighten
by hand.
3. Placecleaning tank (B} over holes (C} on handle
(viewing from front of unit). Push the tree clips (A) into
the holes until they sit fiat against the cieaning tank.
/
/
z/
Insert "L" bolt (A) througil hob just abovecleaning tank
on right side of handJe(viewing from front of unit). Hold
bolt in piace and attach plastic knob (B) from inside of
unit. Tigilten by hand.