Product Specifications; Pressurewasher Specifications - Craftsman 580.752120 Operator's Manual

ENGINETECHNICALiNFORMATiON
This is a single cylinder, L-head, air cooled engine. It is a low
emissions engine.
In tile State of California, Modei I00000 engines are certified
by the California Air Resources Board to meet emissions
standards for 125 hours. Such certification does not grant
the purchaser, owner or operator of this engine any
additional warranties with respectto the performance or
operational Iife of this engine. The engine is warranted soiely
according to tile product and emissions warranties stated
elsewhere in this manual.
Pewer Ratings
The gross power rating for individual gas engine models is
labeled in accordance with SAE (Society of Automotive
Engineers)code J1940 (SmalI Engine Power & Torque
Rating Procedure), and rating performance has been
obtained and corrected in accordancewith SAEJ1995
(Revision 2002-05). Torque values are derived at 3060 RPM;
horsepower vaiues are derived at 3600 RPiVI.Actuai gross
engine power wiii be iower and is affected by, among other
things, ambient operating conditions and engine-to-engine
variabiiity. Given both the wide array of products on which
engines are piaced and the variety of environmentai issues
appiicabte to operating the equipment, the gas engine wiii not
develop the rated gross power when used in a given piece of
power equipment (actual "on-site" or net power). This
difference is due to a variety of factors including, but not
limited to, accessories (air cteaner, exhaust, charging,
cooiing, carburetor, fuel pump, etc.), appiication iimitations,
ambient operating conditions (temperature, humidity,
altitude), and engine-to-engine variabiiity. Due to
manufacturing and capacity iimitations, Briggs & Stratton
may substitute an engine of higher rated power for this
Series engine.
PRODUCTSPECiFiCATiONS
PressureWasher Specifications
Max Outbt Pressure ....................... 2,200 PSi
Max Ftow Rate ............................. 22 GPM
Chemical Mix......................... Use as directed
Water Supply Temperature .......... Not to exceed IO0°F
Shipping Weight ............................. 63 Ibs.
EngineSpecificatiens
Bore ............................... 256 in. (65A rnm)
Stroke ............................. 137 in. (47.6 turn)
Displacement........................ 9.67 in. (158.6 cc)
SparkPlug
Type: ............. Bfiggs & Stratton 802592 or 5095D
SetGap To: ...................... O.030inch(O.76mm)
ArrnatureAir Gap: ........... 0.006-0.010 in.(O.15=O.25mm)
Valveclearance with valvespringsinstalled and piston1/4in.
(6 turn)pasttop deadcenter(checkwhenengineis cold).
Intake .................... 0.005-0.007 in.(0.13-0.18rnrn)
Exhaust .................. 0.007-0.009 in.(0.18=0.23turn)
FuelCapacity............................... 1.0 Quarts
Oil Capacity ........................ 18 Ounces(0.5 liter)
NOTE:For practicai operation, the engine ioad should not
exceed 85% of rated power. Engine power will decrease
3-I/2% for each 1,000 feet (300 meters) above sea Ievei and
1% for each 10° F (5.6° C) above 77° F (25° C). It should
operatesatisfactorily at an angle up to 15°.
15