Craftsman 580.752120 Operator's Manual page 11

HOWTO USEYOUR CLEANING SYSTEM
If you haveany probbms operating your pressure washer,
please call the pressure washer heJpfineat 1-800-222-3136,
Pressure Washer Lecation
PressureWasherClearance
WANNING
Exhaustheat/gases can ignite combustibies,
structures or damage fuei tank causing a fire=
• Keepat least5 ft. (152 cm) clearance on all sidesof pressure
washerincluding o verhead.
Mace pressure washer outdoors in an area that wiii not
accumulate deadty exhaust gas. DO NOT piace pressure
washer where exhaust gas (A) could accumulate and enter
inside or be drawn into a potentiaily occupied building.
Ensureexhaust gas is kept away from any windows, doors,
ventiiation intakes, or other openings that can aliow exhaust
gas to coiiect in a confined area. Prevaiiingwinds and air
currents should be taken into consideration when positioning
_ressurewasher.
WARNING
Running engine gives off carbon monoxide, an
odorless, coiorbss, poison gas.
Breathingcarbon monoxide can cause headache,
fatigue, dizziness, vomiting, confusion, seizures,
nausea, fainting or death=
* Operate pressure washerONLYoutdoors.
, Keepexhaustgasfrom enteringa confinedareathrough
windows,doors,ventilationintakes, o r otheropenings.
* DONOT stat or run engineindoorsor in an enclosed area,
evenif windowsanddoorsare open.
Te Start Yenr Cleaning System
To start your engine=poweredcleaning system for the first
time, foiiow these instructions step=by=step. T his information
also applies whenever you start the engine after you have let
the pressure wa@er sit idle for at bast a day.
1= Piacepressure washer outside near an water source
capabie of supplying water at a flow rate greater than
3=2galions per minute and no iess than 20 PSi at
pressure washer end of garden hose.
2= Checkthat higil pressure hose is tightly connected to
spray gun and pump. See Assemby for iiiustrations.
3= Make sure unit is in a ievei position=
4= Connectgarden hose to water intet on pressure washer
pump.
5. Turn ONwater, point gun in a safe direction and squeeze
trigger to purge pump system of air and impurities.
NOTICE
DO NOT run the pump without the water supply connected
and turned on.
_ amageto equipment r esultingfrom failureto followthis
instructionwill void warranty
6. Piacecolored quick connect spray tips in slots on holder
that's attachedto nozzleextension.
%
7. Attach nozzleextension to spray gun. Tighten by hand=
8. Choose spray tip you want to use and insert it into
nozzle extension=See How to Use Spray Tips.
9. Engagetrigger iock (A) on spray gun trigger.
11