Craftsman 757.242330 Owner's Manual page 5

/
NO 24
Coulter Clamp
Used
Z-1216-C HARDWARE BAG
No 6 P-172P
Coulter Axle O
1 Used.
No 23 P-386P
"U" Bolt
1 Used
ASSEMBLY
NOTES
o IT IS RECOMMENDED THAT YOU CAREFULLY READ THIS
OWNER'S MANUAL BEFORE STARTING ASSEMBLY OF THE UNIT
g Before starting assembly, arrange each kind of
hardware into a group to ease assembly
g Right hand (RH.) and left hand (LH) are determined
from the OPERATOR'S position while seated on the tractor.
IMPORTANT-Mower Deck must be removed when
using Plow to avoid damage to your Deck.
PLOW FRAME
Refer to Fig 1
NOTE: Securely tighten all fasteners ONLY after Plow
assembly has been completed, unless noted otherwise
g Assemble the two adjusting brackets to the inside
of both beams using one t/2"x 1-3/4 '' hex bolt and
one 1/2" hex lock nut
a Slip trunnion through the hote in each adjusting
bracket and insert crank through the hole in
"SIDE"of trlJnnion, through spacer, the two 5/8"
jam nuts, and then thread into the threaded tube,,
e Thread one jam nut against the spacer just enough
to eliminate any excessive movement of the crank
against the trunnion, taking care NOT to bind crank
o Using two wrenches, lock the other jam nut
against the first
e Before assembling the hitch bracket BETWEEN both
beams refer to the chart'and measure the distance
BETWEEN the rear wheels on your tractor for the
proper position of the bracket,
Distance
Between
Rear Tractor
Wheels (inches)
16-19
19-2!
21-23
Over 23
Use Hole #
1R
2L
3L
3L
TABLE 1
Tools Required For Assembly:
1-10" Adjustable Wrench
1- 15/16" Wrench
1_ 13/t6" Wrench
1- 3/4" Wrench
1-Pair of pliers
1- t/2" Wrench
1-9/16" Wrench
1 - Pair Gloves
(Leave modal
plate OUtside)
5/8" I D x 5/8" Spacer
_Jnnion Crank
3L 2L IL
FOP VIEW - WITH HITCH BRACKET
ASSEMBLY TO LEF_..._T SIDE
TOP VIEW - WITH HITCH BRACKET
ASSEMBLY TO RIGHT SIDE
FIG I
g Secure with two 5/8"x 2" hex bolts and 5/8" hex
5
lock nuts