Craftsman 17125455 Operating Instructions Manual page 6

ALTHOUGH YOUR INDUSTRIAL DOVETAIL JIG
COMES A SSEMBLED, THEFOLLOWING ASSEM-
BLY INSTRUCTIONS ARE BEING INCLUDED FOR
REFERENCE PURPOSES SHOULD IT BECOME
NECESSARY FOR YOU TO DISASSEMBLE AND
REASSEMBLE THE DOVETAIL JIG
PROCEED TO THE SECTION ALIGNMENT OF
THE TEMPLATES AND THEN CONTINUE WITH
THE SECTIONS FOLLOWING ALIGNMENT OF
THE TEMPLATES
THE TEMPLATES MUST BE ALIGNED BEFORE
ANY ROUTING tS TO TAKE PLACE
TOOLS REQUIRED
- A medium sized Phillips screwdSver
° A smafl or medium adjustable wrench
ASSEMBLY OF THE RIGHT SIDE TEMPLATE
SUPPORT TO THE DOVETAIL BASE
1 Ptace the dovetail base topside down on a fiat surface
2 insert one of the 5/16-18 x 2" long round head square
FIGURE 1
neck botts into the slot in the right side of the base
(NOTE: The right side of the base is identified by the
words RIGHT SIDE molded into it )
3 Place a 11/32" t D, x 7/8" OD washer onto the bolt as
shown in Figure 1
4 Thread a 5/16-18 hex nut onto the bolt, as shown, until
it bottoms out against the washer
5 Back off the nut from the washer between 1/4 and 1/2
10_32X 5/8" LONG PANHEAD
MACHINE SCREW
HEXES MUST LINE UP
5t16-18 X 2" LONG ROUND HEAD
SQUARE NECK BOLT
t3/64" I D X 9/t6" O D WASHER
"" # 10_32 HEX NUT
"" BACK OF DoVETAiL BASE