Craftsman 17125455 Operating Instructions Manual page 11

7 Loosen thescrew about oneturnRemove theretainer
from the shaft and setitaside t emporarily
8 Assernble thepivot shaft with cam handle tothebase by
inserting theend ofthe pivot s haft through the holes i nthe
right t emplate support and the base
9 MAKE S URE T HE ORIENTATION
OF THE CAM HAN-
DLE IS AS SHOWN IN FIGURE 11
10 Place the retainer at the location shown in Figure 12
and push the pivot shaft through THE ORIENTATION OF
FIGURE 11
CAM HANDLE
PIVOT SHAFT ._
HOLE IN BASE
THE RETAINER RELATIVE TO THE CAM HANDLE WITH
SCREW MUST BE AS SHOWN
NOTE: THE RETAINER MAY FIT TIGHTLY ON THE
PIVOT SHAFT; THIS IS NORMAL,,
11 Continue pushing the pivot shaft through the holes and
the retainer until the end of the pivot shaft extends out of
the teft template support as show in Figure 12
12 Make sure the end of the cam handle fits into the hole
in the base as shown
// RETAINER
RIGHT TEMPLATE
DOVETAIL BASE /
RGURE 12
CAM
HANDLE
HOLE IN BASE
PIVOT SHAFT
i,vo
• ._ ........ HOLE tN
BASE
iA ..............
/LJJ
11