Craftsman 17125455 Operating Instructions Manual page 24

STYLES OF DOVETAIL JOINTS
• Four different styles of dovetail joints can be made with
the Dovetail Jig using your router
• These joints are described in the following sections
Haft Blind Flush Joint
• The Half Blind Flush Joint is used when the height of
both Ihe drawer front and the drawer back is the same
height as the drawer sides; and the length of both the
drawer front and the drawer back is the same as the width
of the drawer
See Figure 37
NOTE: THE NORMAL DEPTH OF CUT FOR A HALF
BLIND FLUSH JOINT IS 318",
FIGURE 37
/ DRAWER FRONT (PiN PIECE)
/
F
DRAWER SIDE (TAIL PIECE)
"_- DRAWER SiDE (TAIL PIECE)
TAILS
\
DRAWER BACK (PIN PIECE) /
24